New 2-in-1 Water Broom Pressure Power Washer Undercarriage Under Car Cleaner

  

1/4 Quick Connect Pressure Undercarriage Under Car Water Broom Cleaner Washer. 39 x 12.3 cm(15.4 x 4.8 inch) (LxW). 1 x Undercarriage Cleaner with Connector.

Suitable for: trucks, SUV, cars, commercial vehicles and trailers. This Is Aftermarket Replacement Item But Not Genuine.

1 All dimensions are measured by hand, there may be small deviations. 2 Color may vary slightly due to the color setting of each individual monitor.

3 2500 PSI or higher will have better cleaning. 1 According to the original factory specifications. 2 Anti-corrosion, solid material, durable long life in use. 3 High efficiency and safe, can enter into some dead zone operations. 4 Easy to operate, easy to install and disassemble.

5 Used outside, such as driveway, side-way, deck, gutter, roof and your car, etc. 6 Undercarriage cleaner& Surface cleaner; Easy to clean and avoid crawling under a vehicle. 7 Clean road grime, oil and fuel contaminants under cars.

Leave your undercarriage clean and dirt free! 8 1/4 inch male plug for quick disconnect.

Easy to connect and release. Works with gas or electric pressure washers. 1 How to Switch Mode: Pull out the nut of the pivoting coupler at the end of cleaner. Then rotate the pivoting coupler to the end.

Finally, the nut will lock automatically. 2 Undercarriage Cleaner Mode: Easy to clean and avoid crawling under the vehicle.

Undercarriage washer is to clean road dirt, oil and fuel contamination under cars. It works as under carriage power washer.

3 Water Broom Mode: Pressure washer surface cleaner attachment is used for quick, easy and even cleaning of surfaces. Power washer surface cleaner is ideal for removing loose debris (sand, leaves, light soil) from sidewalks, driveways, decks, etc. How to Set Up Undercarriage Cleaner.

1 Connect the first straight wand to the undercarriage cleaner. 2 Connect the second straight wand to the first straight wand. 3 Connect the third angled wand to the second straight wand.

4Connect the pressure washer to the third angled wand and unlock the nozzle to spray. How to Set Up Water Broom. 1 Connect the first straight wand to the water broom. 3 Connect the pressure washer nozzle to the second straight wand and unlock the nozzle to spray.